◆Control device: OSPU100L
◆Hydraulic tailstock: Dead type MT No.5
◆Hydraulic chuck: N-10-A08-01A
◆Swing on the bed: Φ620
◆Swing on the carriage: Φ480
◆Distance between centers: 675
◆Maximum processing diameter: Φ420
◆Maximum processing length: 650
◆Movement amount XZ: 300(210 90)×1275
◆Spindle rotation speed: 35 to 3500
◆Number of spindle speed ranges: 2 automatic steps (VAC motor winding switching)
◆Spindle end: JIS A2-8
◆Spindle through hole diameter: Φ80
◆Spindle bearing inner diameter: Φ120
◆Turret: V12M
◆Number of tools installed on the turret: L12
◆Shank height of square tool: 25
◆Boring bar shank diameter: Φ40
◆Turret indexing time: 0.2
◆Fast forwarding speed: X20000/Z25000
◆Cutting feed rate: X,Z0.001~1000000
◆Tailstock shaft diameter: Φ100
◆Tailstock shaft taper hole type: MT No.5 (rotation center)
◆Travel amount of tailstock shaft: 150
◆Spindle motor: VAC 22/15 (30 minutes/continuous)
◆Feed shaft electric motor: X:BL4/Z:BL6
◆Electric motor for cutting fluid: Side discharge of chips: 0.25, Rear discharge; 0.8
◆Power: 29.5 (continuous)
◆Machine height: 2110
◆Required floor size: 3980×1900
◆Machine mass: 5400

*Special specifications
◆Touch setter: M
◆Easy dialogue kit
◆Program store capacity Tape length 320m → 640m

✤If there is a discrepancy between the specifications and the actual product, priority will be given to the actual product.